Directions for Use
1. Ensure the control wheel on the back of the device is in the Off position.
To open, press down the button on the back of the device and pull.
2. Before inserting the aerosol refill, ensure the red lever inside the device is pushed up. Then insert the aerosol refill with the spray nozzle facing out.
3. Close the device. Direct the device away from your face and select desired fragrance intensity using the control wheel located at the back (low, medium, high). When activated, the device will spray after a delay of 15 seconds.
If there's no spray after 15 seconds, switch off the device:
a. Check that batteries are inserted correctly
b. Remove aerosol refill and push up red lever.
c: If Red light is flashing immediately after the first spray, the refill has not been identified as an Air Wick refill and will not work in this device.
4. Directing the device away from your face, place the device where chosen. Ensure it is at least 2m from the floor level.
5. When the aerosol refill is nearly empty, the red light will flash rapidly and the device will soon stop working.
Directing the device away from the face, switch the device to Off position and repeat the operation of placing a new Air Wick refill into the device.
Only use Air Wick refills
