> Accessori per auto > Fogli e tinte per finestrini
Car-window-film, Jet Black, set 76 x 152 cm and 51 x 152 cm
Car-window-film, Jet Black, set 76 x 152 cm and 51 x 152 cm
Car-window-film, Jet Black, set 76 x 152 cm and 51 x 152 cm
Car-window-film, Jet Black, set 76 x 152 cm and 51 x 152 cm

Car-window-film, Jet Black, set 76 x 152 cm and 51 x 152 cm

ID: 31071

23.99€Compra su Amazon

Disponibilità: In Stock

Condizione : Nuovo

ASIN: B00279EXFA

Car-window-film 'Jet Black'Set 76 x 152 cm and 51 x 152 cm o Set for rear window and 2 rear side windows6 % light permeability!General description:Car-window-film set Jet BlackSize: 76 x 152 cm and 51 x 152 cm.Set for rear window and 2 rear side windows.Useable for all types of vehicle.MOT free with ABG (please observe the legal regulations in your country).Inclusive knife and squeegeeUV transmission: 0,5 %Solar energy absorbed: 59 %Light permeability: 6 %2-layered high-quality car-sun protection film of polyester, for highest quality standards.High-quality pressure-sensitive adhesive system (water activatable) with integrated UV-absorber for best long-life stability.By extensive tests by the Rheinisch-Westfälischer TÜV and the department of material control a MOT licence is available and there's no additional registration necessary!Instruction sheet:1. Clean the inside of the windows well with alcohol. Especially the edges. In case of persistant dirt use a razor blade.2. Now lay the film at the inside of the window, so that the transparent protective sheet lies over the particular window. Cut the film corresponding of the windows to be glued, so that 1 cm overlaps all around.3. Remove the transparent protective sheet of the sun protection film, by affixing an adhesive tape on each side. Now you can separate the films easier from each other.4. Spray the adhesive layer of the film and the inside of the window ample with a water-dish liquid-dissolution.5. Mount the on the adhesive side wet film on the window and angle it.6. Spray the mounted film again with the water-dish liquid-dissolution.7. Spread now, with the aid of the squeegee, the water-dish liquid-dissolution under the film outside up to the edges. Thereby you avoid the creation of air bubbles.8. Cut the overlaped film with the aid of a ruler and the including knifeSchneiden There must be a revolving

Potrebbe interessarti anche